If possible, remove and reinstall the optical modules to check whether the fault is rectified. A hyperscale network operator recently discovered that 12% of their 400G DR4 modules—all from an AVL-approved supplier—failed within 90 days of deployment. Root cause analysis traced the failures not to a design flaw, but to a contract manufacturer switching laser bonding adhesive without. However, the failure of optical modules is a common problem during use, which not only affects the network quality, but also may lead to network interruption. The following are notes on the use of Gigabit optical modules and 10Gb optical modules, some common causes of failure and the corresponding. If the optical module is installed on a GE port, run the display interface GigabitEthernet x/x/x command to check information about the port, including the rate and wavelength. However, during installation and daily operation, various issues may arise.
