-
Measuring motor current in the distribution box
The most common method to read the current flowing in a motor is to use a resistor connected on the source of each low side MOSFET of the power stage. The value of these resistors ranges from few milliohms to hundreds of milliohms, depending on the target current in the. Document information Information Content Keywords Current sensing, sensing techniques, motor control Abstract There are many ways of current measurement in motor control or power electronics applications. Moreover, electrical current can be measured with different sensor types. Due to the continuity of the measurement signal and direct correlation to the phase currents, an ideal location to measure the motor current is directly in-line with. Measuring at motor (properly) will give current going into motor. I'm assuming that the controller is in between. It depends on. input elements. For example, six elements allow for the inputs and outputs of a three-phase AC drive system, with two more required to measure torque and speed output from the motor. We'll cover the necessary steps, safety precautions, and common challenges.
[PDF Version]
-
PLC Optical Splitter Chip Principle
A PLC splitter is a passive optical device that divides one incoming optical signal from an input fiber into multiple output signals across several output fibers. PLC splitters utilize a planar lightwave circuit chip made of silica glass waveguides to distribute the optical power. As a core device in FTTH and PON networks, a PLC splitter is not just about “splitting light” — it's about delivering stable, low-loss, and uniform optical power distribution at. PLC optical splitters (planar waveguide optical splitter) is a key component in optical fiber communication networks and is widely used in optical fiber distribution systems such as FTTH (fiber to the home) and PON (passive optical network).